Graco #FFT310 - RAC 5 SwitchTip - 6-8 inch Line Width
Price: $38.40 Retail: $49.00 You Save:$10.60
This item is in stock
Graco #FFT-310 - Fine Finish RAC X SwitchTip - for 6-8 inch Line Width
Reverse-A-Clean(RAC)SwitchTips are the highest performing and longest lasting tips in the industry! RAC X Switchtips (green handle) is designed to maintain a wider spray pattern for a longer period of time. A wider spray fan means fewer passes with the gun and better productivity.
RAE Item #
Graco Part #
RAC X SwitchTip - (Green Handle)
RAC X Fine Finish SwitchTips spray at lower pressures than standard tips and Fine Finish RAC 5 tips
You'll experience less overspray and a tighter, more consistent fan pattern
RAC X Fine Finish SwitchTips offer superior atomization
Converts your Graco airless sprayer into a high production fine finish spraying system
One (1) Graco RAC X Switchtip, One (1) black rubber gasket, One (1) metal seat, and One (1) yellow solvent gasket. Can be shipped international or domestic. Shipping Dimensions are: 5 inches long x 4 inches wide x 1 inches high.
0.010 inches (orifice size)
6-8 inch fan (line width)
0.11 gpm (flow rate)
0.41 lpm (flow rate)
Tip Guard Assembly
Black Rubber Gasket, Seat, and Yellow Solvent Gasket
A black rubber gasket and metal seat are packaged with each SwitchTip spray tip. The black rubber gasket allows the SwitchTip spray tip to be removed and replaced without using tools. Always use a wrench to tighten the tip guard nut onto the gun nozzle.
Fully insert the SwitchTip spray tip into the housing.
Tighten the guard onto the gun nozzle using a wrench to snug it. Do not overtighten.
Be sure the handle of the SwitchTip spray tip is in the FULL SPRAY or FULL CLEAN position, which is parallel to the nozzle of the spray gun.
Use the black rubber gasket ONLY with latex and oil-based paints, stoddard solvents, mineral spirits, turpentine, and water.
With all hot solvents, including lacquer thinner, MEK, trichloroethane, acetone, brush cleaner, xylol, any unknown solvents, use only the yellow plastic gasket. The yellow gasket can also be used with the solvents listed for the black gasket.
Additional gaskets and seats are available by ordering part number 243004.
Failure to install or use the RAC IV tip guard assembly correctly may result in an undirected spray of paint into the eyes or on the skin of the operator. Be sure you:
Fully insert the SwitchTip spray tip into the guard.
Turn the SwitchTip handle so it is parallel to the gun nozzle.
When replacing a worn spray tip, always install a new gasket and seat.